What is softpierce percentage in sheetcam full#
The post is for Development and BETA but we use it on a daily basisįor you guys with the full TAP (Total Automated Plasma) using the Hypertherm RS485 optionand our HyT-Connect RS485 SIM kit, you can play around with the "Soft Pierce Percent" setting. Contact me via e-mail direct or post on the support forum listed below. It works for any toolpath (line, arc, circle). One adds a parameter named "Minimum Cut Length" with a defautl value of 1" It will look a the toolpath and any cut with a total length LESS than the preset will prevent the DTHC from even turning on at all. I have a new post that adds in some auto features that you might be interested in. That is a good place to put the end of cut DTHC off clip) In TNG development Les has put in a global cut rule (one per job) that will apply that rule to the entire job. The Tip Saver anti dive works pretty good on the DTHC II based units for anti dive but the new DTHC IV is so much faster tahn the DTH CII that it reacts quicker than the TIP SAVER can.
What is softpierce percentage in sheetcam code#
375 or more depending on the feedrate and use the DTHC off code clip and it will shut it off just before the end.
You just set a rule for "Before End of Cut" with a distance of about. Scott: If you use our POSTS with DCC in the name and our toolsets we include in the SheetCAM Support Installer and a POST from there that has the DCC in the name than you will have pre-canned code "snips" to do things like turn the DTHC (not the THC in MACH that will cause a motion pause) ON/OFF using custom S commands.
0 kommentar(er)
